September 2011

#1: Pre-Remount Inspection

Step #1: Pre-Remount Inspection Before the inspection, all carry-on equipment is removed from the module and a thorough inspection is performed to evaluate any non working components. (Radios, inverters and other mechanical devices will need to be removed before the remounting phase.) During the inspection, we...

0
0

#2: Demounting Module

Step #2: Demounting Module We remove the module body from the old chassis using overhead slings, taking special care to not bend, damage or disfigure the structure. Also during this phase … ● All HVAC and electrical harnesses connecting the module to the chassis are disconnected on...

0
0

#3: Electrical Console

Step #3: New Electrical Console While the module is being painted, we prep the new chassis with a new front console and switch panel. This picture shows our standard Type I console (splatter paint finish). The electrical system from the main electrical distribution panel is completely...

0
0

#4: New Chassis Preparation

Step #4: New Chassis Preparation Preparing your new chassis involves a number of aspects, including: Mounting "Outriggers" with rubber isolators are installed along the frame of the chassis for mounting the new module. This creates and isolation between the aluminum frame of the module and the steel...

0
0

#5: Remounting Module

  The module is remounted onto the new chassis using the same overhead slings as described in Step #2: Demounting. During this phase … ● New seals between the module and chassis frame are installed using materials equal to the original seals. The module will NOT be welded...

0
0

#6: Equipment Reinstallation

All electrical harnesses, hoses and mechanical devices from the old chassis are reinstalled on the new chassis. This step also includes the following: ● All chassis wiring is to be in conduit or looms and grommets are installed at all locations where wiring goes through metal...

0
0

#7: Final Inspection

After the remounting and re-installation of all accessory equipment, we'll complete a final inspection form for each item tested prior to remount. (All electrical system components on the module and chassis that were operating before the remount will be working during this test.) We complete...

0
0

Optional Services

Your remount can involve cosmetic services to restore the interior and exterior appearance of your ambulance. These enhancements may include: - Completely repainting the module with PPG single stage urethane paint system. - Upgrading all lighting to LED. - Install a reflective stripe or graphics....

0
0